CAF Resistant,Reinforced Microvia Dielectrics
This paper discusses the results of Conductive Anodic Filament (CAF) testing of three types of reinforced microvia
dielectrics using a CAF test specific Printed Circuit Board (PCB). Quantitative results are presented for two CAF
testing modes of failure for microvia layers: HDI layer-to-HDI layer and microvia hole-wall-to-microvia hole-wall.
Some additional data was also collected for the core material conductor-to-hole-wall configuration. The study
demonstrated that a glass-reinforced prepreg and two types of micro-reinforced prepregs,all used in microvia
construction,pass CAF testing. Additional significant factors relating to microvia PCB fabrication and reliability are
presented as they relate to decisions regarding use of CAF resistant materials.
Materials used in PCB fabrication,particularly those containing glass fibers (but not necessarily limited to them),
are susceptible to CAF growth. This growth,if it occurs,will lead to field failures. Often,these field failures are
"self-healing" and the root cause of the failure is not detected. The condition then reoccurs when product is placed
back in service. Other times,the failure is a hard fault and will result in a detectable short circuit. The occurrence of
CAF failures is not just limited to environmental factors; material selection,application,fabrication processes,and
design considerations also impact the growth of,or potential growth of,conductive filaments.
There is much work in the industry to develop and test CAF resistant dielectric materials. As many PCBs are
moving to microvia technology in order to minimize PCB size and maximize PCB function (electrical and design
density),additional factors must be considered when incorporating CAF resistant microvia dielectrics. In particular,
the ability to manufacture high quality and low cost (low material cost and PCB process costs) microvia layers is
equally important to passing CAF. Non-reinforced dielectrics have been shown to be CAF resistant but they can
result in failures from other environmental conditions such as thermal or mechanical stress. Because of these stress
related failures,the industry is moving to the use of reinforced microvia dielectrics as the solution. There are three
classes of reinforced microvia dielectrics: glass fabric,random chopped fiber (e.g. aramid or LCP),and microreinforced
(e.g. expanded PTFE). This paper focuses on two types of dielectric reinforcements: glass fabric and
micro-reinforcement.