Advanced Laminate and Prepreg for PWBs with Embedded Components
The technology for embedding components in PWBs will change the process how PWB are fabricated over the next
few years. At the present time,polymer thick film is the most frequently used material to embed “passives” in
PWBs. However,these do not meet the stringent tolerances that will be needed in the future and will be replaced by
new materials based on ceramic,thin film or even with silicon. The coefficient of thermal expansion (CTE) of such
new technology embedded components is,in most cases,lower compared to the CTE of standard glass-reinforced
materials used today. In addition,the distance between the component lead and the PWB connection will be shorter
and will thus absorb less stress. For the effective use of embedded components,the dielectric thickness between the
conductive layers will be reduced. High dielectric strength,CAF resistance and low migration are required,while
resin recession cannot be accepted on plated inner via holes. This paper explains the impact of CTE imbalances
caused by the different materials used in a PWB. It also provides guidance on how PWB manufacturing process can
be modified to accommodate the new requirements from the PWB fabricators,assemblers and OEMs. These
requirements are for high dimensional stability of the laminate and prepreg to improve manufacturing yields during
bare PWB fabrication,during assembly and during the life cycle of the electronic device in the field. The paper also
explains the risks of metal migration and conductive anodic filaments (CAF) in PWBs and the need for lower
dielectric constant (Dk). The new materials are processable in standard PWB fabrication lines and can accommodate
the needs engendered by halogen-free resin systems.